You are here


Ski Service

"Pierce Skate & Ski is one* of the top shops in the country for boot fitting and ski tuning" -Skiing Magazine, October 2005


Pierce has always aimed at being #1.  Here are some of our Midwest Service Center "1st"s:

  • 1st Montana Stone Grinder
  • 1st Montana Stone Grinding Robot
  • 1st Huber Electronic Binding Tester
  • 1st Montana Parallel Stone Grinder
  • 1st Montana Snow Star Stone Grinder
  • 1st shop to offer Montana Radial Tuning
  • 1st Montana Wax Future

Stone Grinding

Typically found only in World Cup race rooms, our Montana Snow Star was the 1st in North America.  It simultaneously grinds a pair of skis perfectly flat.  We are also able to "structure" the base to enhance glide properties for specific snow conditions.  

Net Result = Easier Turns &  Enhanced Glide

Edge Preparation

Edge work is a combination of 3 Montana machines; the MCS-2000 side edger, the HTT 3-D radial base edger and the HTT Dually side edge polisher.  

Net Result = Superior Hold & Easier Turns


In July 2010 we added our new Montana Wax Future. This race room proven technology uniformly applies any type of wax using an infrared reflective beam heating only the polyethylene base.

Net Result = Superior & Longer Lasting Glide

Binding Installation

All binding work at Pierce is performed by Certified Technicians.  For 40+ years no one has installed more bindings in the Midwest the "The Man with the Golden Arm" Larry Lindstrom (pictured).  

From systems to Biostance prescriptions we have you covered.

Binding Callibration

Skiing involves risk that can be reduced through the use of good equipment that is properly calibrated.  We leave nothing to chance as we use the same machines used at the binding factory to monitor quality control.  All bindings serviced are electronically calibrated according to skier height, weight, age, boot sole length & ability.

Meet the Service Staff

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer

Fatal error: Class CToolsCssCache contains 1 abstract method and must therefore be declared abstract or implement the remaining methods (DrupalCacheInterface::__construct) in /home/content/71/5285971/html/2012site/drupal7/sites/all/modules/ctools/includes/ on line 52